![]() ![]() To prevent this, simply unplug the battery to turn the vehicle off, instead of holding the EZ-Set button. Note: A common cause of a red/green flashing LED is holding the EZ-Set button too long when turning a vehicle off. If the ESC shows a steady red light, the procedure was a success, and your vehicle is ready to drive. When this happens, release the EZ-Set button and the transmitter trigger.Ĩ. You may also hear three beeps from the motor, or a descending musical tone. The light on the ESC should turn off for 5-10 seconds, then turn steady red. #Press the red button once after blue but before green full#While still holding full reverse, press and hold the EZ-Set button on the ESC.ħ. so which button do you press you press the button labeled 'blue', but is actually red. in between the buttons is a piece of paper telling you to press the red button. The light on the ESC should turn steady or blinking green. there is a table with two buttons, the first is red, but labeled blue and the other is blue, but labeled red. At this point, push and hold the transmitter trigger to full reverse. ![]() The light on the ESC should flash red twice. At this point, pull and hold the transmitter trigger to full throttle.ĥ. If you want to use the button as a toggle so that anytime it is pressed it will change the color of either the button itself or another control, you. The light on the ESC should flash red once, then shut off. If you want to change the color of the button while its pressed, you can change the PressedColor (for the font color) and PressedFill (for the background color) of the button. ![]() Let go immediately when the light turns red.Ĥ. The ESC light will turn on green, then turn red. Press and hold the blue EZ-Set button on the ESC. Plug a fully-charged NiMH battery into the ESC.ģ. They provide better loot than Medium puzzles, and are the. If you do not have a LiPo battery, then follow the procedure below to switch the LVD to "OFF".Ģ. Advanced tier puzzles are accessible once youve obtained a red card from Medium (Blue) puzzles. Then you can simply switch the LVD to "OFF" by holding the EZ-Set button until the light switches to red. The light on the ESC should be steady green, indicating the LVD is "ON". If you have a Lithium Polymer (LiPo) battery, connect it to the ESC and turn it on. When using a NiMH battery in your Traxxas vehicle, it is important that the LVD remains "OFF". If the Low-Voltage Detection (LVD) is "ON" when a nickel-metal hydride (NiMH) battery is used an ESC may show the over-voltage alarm, indicated by a flashing red and green light. This article is designed to help when the LED on an ESC is flashing red and green. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |